Description
Hand made from resin and high quality alcohol inks. Top coated with another layer of clear resin for added “juiciness”.
Necklace dimensions: 4.3cm long incl. bail / 3.6cm x 3cm width
Clean with a soft microfiber cloth and a bit of water if needed. Store out of direct sunlight.
Comes with 2 cord options: Measurements are from end to end
- Adjustable sliding knot waxed cotton cord 64cm (25.2″) long maximum. Can be made shorter by sliding knots apart.
- Waxed black cord including 4.5cm (2″) stainless steel chain extender with lobster claw clasp. Total length 48cm (19″).
Adjusting Your Necklace with a Sliding Cotton Cord
- Locate the Sliding Knots: On both sides of the necklace, you will find sliding knots attached to the waxed cotton cord.
- To Shorten the Necklace: Pinch the knots between your thumb and forefinger and slowly pull the knots apart. This will make the necklace shorter and the pendant will sit higher on your neck.
- To Lengthen the Necklace: Hold onto the cord (just below the knots) in each hand and gently pull the cord apart (<—->). You will see the knots sliding closer together. This will allow the pendant to drop lower, creating a longer necklace. Be sure to always leave a small gap between the knots to make it easier to pull them apart again to shorten the necklace later if desired.
Reviews
There are no reviews yet.